Skip | Home | Site Map | Terms and Conditions | Feedback Form | Keys

Share

Partikl 3 User Guide

back | next

Partikl Controller Unit: Amplifier

Controller Amp screenshot, small

Overview

If you have a weak signal, coming from a filter for example, then pump it into an amplifier. The Amplifier can multiply the input by a factor of up to 5. If you want more than this, feed it into another amplifier!

The main controls in this unit are:

XY checkbox: Checking this will display an XY grid where up/down is volume and left/right is pan position of the signal (response times may be slow and "drag memory" long depending on device).

Gain: This determines the amount of amplification to be done by this amplifier unit. The default value is 1.00 (no amplification).

Pan: This determines the pan position of the signal. The default value is 64 (center).

Invert phase: Checking this box will invert the phase of the signal

Invert pan: Checking this box will invert the pan of the signal