Partikl FX Unit: Distortion

Overview

Distorts the sum of your incoming signals. Take cutoff X right down to about 0.02 to get a really distorted sound - it sounds great on a particle system! Cutoff Y acts like an amp and Cutoff Max determines the position of the output wave when the input is at 1.0 or -1.0.

Graph of the Distortion Cutoff parameters

The main controls in this unit are:

Cut X: This determines the input value which will be scaled to the output value of 'y'.

Cut Y: As above, i.e. at input 'x', 'y' is the output.

Cut Max: At input value of 1.0, the output is 'Max'. Max may even be set to be lower than Cutoff Y

The combination of Cutoff X, Y and Cutoff Max contribute to reshaping the input signal.

Wet Level: Adjust this value to alter the amount of "wet" (processed) signal in the mix.

Dry Level: Adjust this value to alter the amount of "dry" (unprocessed) signal in the mix.