Partikl FX Unit: Equaliser

Overview

You can use the Equaliser plugin to modify the frequency response of your audio signal. Depending on how you configure the plugin, it can operate as either a 5-band or a 10-band equaliser. Note that the 5-band equaliser takes less CPU power.

The main controls in this unit are:

On/Off checkbox: Use this to enable or disable the EQ

Lock checkbox: Use to allow all sliders to move together at the same time when you change any one of the individual slider values.

EQ bands: Specify the gain for the indvidual frequency bands. Adjust from -14 dB to +14 dB. Unused frequency bands will display "N/A" in case of 5-band EQ mode, or if band frequencies are close to or above half the sample frequency.

Amp: Specifies the amount of pre-amplification applied to the equaliser input signal. Adjusts from -20 dB to +20 dB.

Base: This slider adjusts the frequency of the lowest EQ band. All other sliders will automatically follow to maintain the frequency ratio between bands.